60-Amp Pro Switch-Mode BEC Brushless ESC (V2) (EFLA1060B) by E-Flite

Codice prodotto: EFLA1060B
Produttore: E-Flite
Il prezzo della consegna standard per questo articolo è di €9,50 (la spedizione è gratuita per ordini superiori a 99€). Gli ordini inseriti oggi prima delle 15.00 CET verrano evasi entro le 24 ore successive (eccetto per articoli su ordinazione/presso fornitore/non in stock).
Disponibilità limitata
97.90€ iva inclusa

60-Amp Pro Switch-Mode BEC Brushless ESC (V2) BY E-FLITE (EFLA1060B)


The E-flite® 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.

  • Up to 60 amps continuous current with proper air flow and 75 amps burst current (15 seconds)
  • 5A continuous current, 5V switch-mode BEC circuit (proper cooling and airflow required)
  • Stronger BEC for support of most 3-axis stabilization systems
  • Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage
  • 3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
  • Finned heat sinks
  • Programmable motor braking
  • Safe power-arm mode prevents accidental starts
  • Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
  • Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
  • Programmable soft start for helis and airplanes
  • Auto motor shut down if signal is lost or there is interference
  • Programmable timing—5 user-selectable ranges for use with a large variety of brushless motors
  • Utilizes new smaller MOSFET technology to minimize weight
  • Radio system power on/off switch
  • Pre-wired connectors—E-flite® EC3™ connector on battery input and 3.5mm gold bullet connectors on motor output leads
  • Amperage:  40-60
  • Brake:  Yes - Programmable
  • Cells w/BEC:  3-6S Li-Po or 9-18 Ni-MH/Ni-Cd
  • Continuous Maximum Current:  50 - 75A
  • Height:  0.61 in (15.5mm)
  • Input Connector Types:  EC3
  • Input Voltage:  10.8V - 22.2V
  • Length:  2.85 in (73.0mm)
  • Momentary Peak Current:  15 sec @ 75A with proper cooling air flow
  • Output Connector Types:  13 AWG with 3.5mm female gold bullet connectors
  • Type:  Brushless
  • Weight:  2.65 oz (75.0 g)
  • Width:  1.30 in (33.0mm)
  • Wire Gauge:  13AWG
60-Amp Pro Brushless ESC (V2) Manual.pdf1.05 MB

Prodotti più venduti